THE FILM FOOTAGE ANCIENT ALIENS DID NOT SHOW YOU!
Many have speculated that mystical forces were used to move the Coral blocks that weighed many Tons. Edward Leedskalnin understood HOW the PYRAMIDS WERE CONSTRUCTED and knew the laws of weight and leverage. This video shows actual film footage of Ed moving the blocks by himselfSHORT VIDEO AT LINK BELOW SHOWS .Edward Leedskalnin ELEVATING THE BLOCKShttps://www.youtube.com/watch?v=_2SmmSD0afg
**CORAL CASTLE MUSEUM WEBSITE**What makes Edís work remarkable is the fact that he was just over 5 feet tall and weighed only 100 pounds. In this part of Florida, the coral in some areas can be up to 4,000 feet thick. Incredibly, he cut and moved huge coral blocks using only hand tools. He had acquired some skills working in lumber camps and came from a family of stonemasons in Latvia. He drew on this knowledge and strength to cut and move these blocks.
Ed had lived in Canada, California, and Texas but when he developed a touch of tuberculosis, he decided to move to a better climate to help his condition. Ed moved to Florida in 1918 and lived in Florida City until about 1936. Ed was a very private person and when he heard about a planned subdivision being built near him he decided to move to Homestead and in 1936 bought 10 acres of land. Ed spent the next three years moving the Coral Castle structures he had already begun to build from Florida City to Homestead, a distance of 10 miles.
How did Ed move all these carvings a distance of 10 miles? Ed had the chassis of an old Republic truck on which he laid two rails. He had a friend with a tractor move the loaded trailer from Florida City to Homestead. Ed lived a very simple life; he did not own a car. Instead, Ed would ride his bicycle 3.5 miles into town for food and supplies on a regular basis.
*VISIT THE MUSEUM WEBSITE AT THIS LINK http://coralcastle.com/whos-ed/
This is from Ed Leedskalnin's Magnetic Currents book..."Bend
"iron or soft steel bar one and one half inch in diameter, bend in a U
shape each prong a foot long, and three inches between the prongs,
make two spools from brass or aluminum six inches long and big enough
for the bar to go in. Wind fifteen hundred
turns of insulated copper wire, size sixteen, on
each spool. On as close to the bend as it will go. Connect the
battery with the coils so that each current is running in both coils at
the same time, and so that one end of the bar is North Pole and the
other South Pole, you now an electric
the six-inch long square rod on top of the two iron prongs, fit good so
it lies even. Connect the battery with electric magnet for a little
while, now disconnect the battery, connect the
light bulb with the electric magnet the same way it was connected
with the battery, now pull off the six-inch long bar, do it quickly,
then you will see light in the bulb, connect the battery up again with
the electric magnet, put the bar
across the iron prongs, hold awhile, disconnect the battery.
Now the electric magnet holds perpetual motion. If
not disturbed it will last indefinitely. I held it in this position for
six months, and when I pulled off the
six-inch bar I got just as much light out of it as I got in the
first time. This experiment shows that if you start the North and South
Pole individual magnets in an orbit, then they will never stop."
I ran across a well done series of videos which claimed to have "broken the code" and revealed the "secret" to how Ed Leedskalnin built the Coral Castle. You know... it's funny how people totally ignore the obvious. There are actually pictures of Ed LeedskalEd Leedskalnin's tripodnin with huge tripods and big block & tackle hoists moving the stones...
FULL ARTICLE WITH MORE PICTURES AT THIS LINKhttp://www.electricitybook.com/coral-castle/